AC Installation and Replacement in Keller, TX
- HONEST
- RELIABLE
- PROFESSIONAL
Contact Us
Keller developed differently from most DFW cities. Rather than filling in from a historic core outward, it grew as a destination — an affluent suburb that attracted large-footprint homes and high expectations for indoor comfort beginning in the late 1980s and accelerating through the 2000s. Many of those homes are now 20 to 30 years old, and the original or first-replacement HVAC systems inside them are reaching the end of their service lives at exactly the moment when those homes are most costly to keep uncomfortable. Large square footage, tall ceilings, and multi-zone layouts mean that a failing system in Keller carries consequences that a smaller home simply doesn’t face in the same way.
These are the signs Keller homeowners most commonly encounter before a replacement becomes unavoidable:
- One or more zones in a multi-system home are consistently underperforming while others keep up, pointing to uneven equipment aging across systems that were installed at the same time.
- The system runs for extended periods without meeting the thermostat setpoint on afternoons above 100 degrees, a sign that capacity has declined enough to fall short of peak demand.
- You’ve had a refrigerant leak repaired and the charge has needed to be topped off again within two seasons, which almost always means the leak has recurred at the same point or opened elsewhere.
- Your energy bills have increased significantly year over year without any change in thermostat settings or household occupancy, indicating efficiency loss in aging equipment.
- The system is 15 or more years old — on the longer end of typical service life even under good conditions — and any major component replacement at this stage is unlikely to deliver meaningful return on investment.
- Humidity control has deteriorated noticeably, with the home feeling clammy in the mornings even after the system has run overnight, a sign the equipment can no longer manage moisture effectively alongside temperature.
In a home of Keller’s typical size and complexity, catching these signals early and planning a replacement on your terms is considerably better than responding to an emergency in mid-July.
our services
The Conditions Behind AC Wear in Keller's Newer Homes
Keller’s housing stock presents a different set of HVAC challenges than older DFW cities. The homes here are newer, larger, and built to higher initial standards — but those characteristics come with their own set of performance demands that, after 20 to 30 years, create failure patterns distinct from what you see in the post-war ranch homes of Bedford or Mesquite.
These are the primary local and structural factors that contribute to AC wear in Keller:
- Keller’s large two-story homes — many exceeding 3,000 square feet with open floor plans, two-story entry foyers, and bonus rooms over garages — place exceptional demand on HVAC systems because volume-heavy spaces like vaulted great rooms and two-story entries are disproportionately difficult to condition and can overwhelm systems that were marginally sized at installation.
- The city’s position in northern Tarrant County along the Fort Worth prairie puts it in the path of powerful north and northwest wind events that accompany cold fronts in fall and winter, driving significant temperature swings that place repeated thermal stress on both heating and cooling equipment across the seasons.
- Many Keller homes from the late 1980s through early 2000s were built with two or more separate HVAC systems serving different zones — a configuration that ages both units simultaneously, meaning homeowners often face the prospect of replacing multiple systems within the same short window rather than spreading replacements out over years.
- The expansive clay soils across northern Tarrant County shift more dramatically with Keller’s seasonal rainfall variation than the more urbanized areas to the south experience, which can gradually stress refrigerant line sets running along or beneath slab sections and introduce slow leak points over time.
- Large attic spaces over Keller’s two-story homes accumulate significant heat loads in summer — often exceeding 150 degrees — which stresses air handlers and duct systems located in those spaces and increases the effective load the system must overcome to deliver conditioned air to upper-floor rooms.
The cumulative effect of these factors explains why Keller homeowners frequently find their systems declining ahead of what the equipment’s rated lifespan would suggest.
Our AC Installation and Replacement Services in Keller, TX
Ellis Air Conditioning and Heating has served Tarrant County and the broader DFW area for over 50 years. In Keller, that means working with some of the largest and most complex residential properties in the region — homes where getting the system sizing, zoning strategy, and duct design right has a proportionally larger impact on comfort and operating cost than it does in a smaller home.
Our Keller AC installation and replacement services include the following:
- A thorough in-home evaluation that assesses every system in the home — including multi-unit configurations — along with ductwork condition, attic heat exposure, zoning setup, and the specific comfort challenges your floor plan and ceiling heights create.
- A Manual J load calculation that accounts for Keller’s local climate, your home’s volume and layout, attic conditions, and any high-load spaces such as vaulted ceilings, bonus rooms, or two-story entries that require additional attention.
- Full removal and EPA-compliant disposal of existing equipment, including proper refrigerant recovery for all systems being replaced.
- Installation by NATE-certified, factory-trained technicians in fully stocked service vehicles, with most standard replacements completed in a single visit.
- Ductwork inspection and repair or sealing as needed, with particular attention to attic duct runs serving upper-floor rooms where insulation and joint integrity directly affect system performance.
- Full system commissioning including startup testing, refrigerant charge verification, airflow measurement at all registers, and a complete homeowner walkthrough covering all systems and zones.
Every estimate is free, every proposal is written and itemized, and no work begins until you have reviewed and approved the full scope.
Inside a Typical Service Visit: A Keller Two-Story Replacement
Last fall, we were called out to see Christine, who owned a 3,400-square-foot two-story home in a subdivision off Keller Parkway in central Keller. The home was built in 1998 and had two separate HVAC systems — one serving the downstairs and one serving the upstairs. The upstairs unit had been repaired twice in two years, most recently for a failed capacitor, and Christine had been told by a previous contractor that the system had at least two or three more years left. By September, it was struggling to keep the upper floor below 79 degrees even on mild days.
Our technician’s inspection told a different story. The upstairs system was the original 1998 unit — 25 years old and operating at a fraction of its rated capacity. The downstairs unit was a 2012 replacement that was performing adequately but showing its own signs of age. The attic duct system serving the upstairs had several flex runs that had sagged and kinked over the years, reducing airflow to the front bedrooms significantly. The return air configuration for the upstairs system was also pulling primarily from the hallway rather than from the rooms with the greatest heat load, leaving the bonus room over the garage chronically starved for cooling.
We replaced the upstairs system with a correctly sized unit, re-routed and re-supported the sagging flex runs, and added a dedicated return air pathway into the bonus room. Christine’s upper floor hit its target temperature consistently for the first time she could remember. She also asked us to evaluate the downstairs system while we were there, and after reviewing its age and condition, decided to schedule that replacement before the following summer rather than wait for it to fail on its own terms.
Why Keller Homeowners Trust Ellis Air Conditioning and Heating
Keller homeowners expect a high standard of service — the homes here are significant investments, and the contractors working in them need to match that standard. Ellis Air Conditioning and Heating has been delivering professional HVAC installation and service across the DFW area since 1975, and the qualities that have sustained that reputation over five decades are exactly what larger, more complex homes demand.
- More than 50 years of continuous service in the Dallas–Fort Worth area gives our technicians direct, hands-on experience with the large-footprint homes, multi-system configurations, and northern Tarrant County conditions specific to Keller.
- Our technicians average over 10 years of tenure with Ellis, giving you the benefit of seasoned diagnostic judgment on installations where the stakes — and the complexity — are higher than average.
- As a Carrier Factory Authorized Dealer, Ellis meets rigorous manufacturer standards for training and installation quality that protect your equipment performance and keep manufacturer warranty coverage fully intact.
- We hold a BBB A+ Rating, NATE certification, and TDLR licensing under Texas License TACLB002064, independently verified credentials that reflect our commitment to professional, accountable work on every job.
- Our large fleet of fully equipped service vehicles allows us to respond promptly across Keller and northern Tarrant County and complete most installations without return trips for parts.
- We provide 24/7 emergency service, free in-home estimates, and written proposals with fully transparent pricing before any work begins.
When the home is this size and the system this complex, experience is not a nice-to-have — it is the baseline requirement. Ellis brings it on every job.
AC Installation and Replacement in Keller, TX
Ellis Air Conditioning and Heating serves Keller, TX homeowners with AC installation and replacement services backed by more than 50 years of experience in the Dallas–Fort Worth area. Keller is a city where the homes are large, the expectations are high, and the consequences of an underperforming HVAC system are felt across thousands of square feet rather than hundreds. A system that is marginally sized or hastily installed in a 3,500-square-foot two-story home does not just fail to impress — it fails to function, and the costs show up on every electric bill and every uncomfortable afternoon until it is replaced properly.
What Keller homes require is an installer who takes the complexity seriously from the first visit forward. Multi-system configurations, vaulted spaces, bonus rooms over garages, and large attic cavities with aging flex duct runs are not edge cases in this city — they are the norm. Our technicians are experienced with all of it, and we approach every Keller installation with the thoroughness that homes of this scale demand.
Call today for a free in-home estimate. We will assess every system in your home, evaluate your ductwork and zoning, and give you a written proposal with honest recommendations and transparent pricing.