AC Installation and Replacement in Irving, TX
- HONEST
- RELIABLE
- PROFESSIONAL
Contact Us
Irving sits squarely in the heart of the DFW Metroplex, where summer heat arrives early and lingers well into October. For homeowners here, the air conditioner is not a seasonal convenience — it is essential infrastructure. Catching the warning signs before a full breakdown can spare you from an emergency replacement in the middle of a heat wave.
Watch for these indicators that your system may be due for replacement:
- Your system is 12 years old or older and has required at least one significant repair in the past two seasons.
- Humidity feels heavy inside your home even when the AC is running, which points to a system that is no longer managing moisture effectively.
- You hear unusual sounds — grinding, rattling, or clicking — that weren’t present when the system was newer.
- Your utility bills spike each summer in a way that outpaces rising rate increases, suggesting the equipment is losing efficiency.
- The system uses R-22 refrigerant, which is no longer in production and has become expensive and difficult to obtain.
- Airflow from your vents feels noticeably weaker than it used to, even with a clean filter in place.
These signs rarely appear all at once, but even two or three together are a strong signal that replacement is worth evaluating sooner rather than later.
our services
Why Irving Homes Are Hard on Air Conditioning Equipment
Irving’s position between Dallas and Fort Worth gives it a particular set of climate and infrastructure conditions that wear on HVAC equipment faster than homeowners often expect. The city spans a transition zone where the Trinity River floodplain meets denser suburban development, and that geography has real consequences for the systems inside homes.
Several local factors contribute to accelerated AC wear in Irving:
- Proximity to the Trinity River corridor means elevated ambient humidity, especially in the Las Colinas and Valley Ranch areas, which forces systems to work harder to maintain indoor comfort levels.
- Irving’s housing stock includes a large number of homes built in the 1970s through early 1990s — many of which have original ductwork that has never been inspected or sealed, creating significant efficiency losses.
- The city’s flat topography and high concentration of commercial and paved surfaces intensifies urban heat island effects, raising outdoor temperatures beyond official readings and increasing the load on residential condensers.
- DFW International Airport’s proximity generates consistent low-level vibration in some neighborhoods, which over time can loosen electrical connections and refrigerant line fittings.
- Spring storm systems that track along the I-30 corridor frequently produce power surges that damage capacitors and control boards in residential AC units.
Understanding these local stressors helps explain why Irving homeowners often find themselves replacing systems earlier than the national average lifespan would suggest.
Our AC Installation and Replacement Services in Irving, TX
Ellis Air Conditioning and Heating has installed and replaced cooling systems throughout Irving and the broader DFW area for over 50 years. Every installation we perform is built around what your specific home actually needs — not a generic recommendation based on square footage alone.
Our Irving AC installation services include the following:
- A complete Manual J load calculation that accounts for your home’s orientation, insulation, window area, and local climate data.
- Full removal and disposal of your existing equipment in compliance with refrigerant handling regulations.
- Installation by NATE-certified, factory-trained technicians who follow manufacturer specifications on every job.
- Ductwork inspection and sealing recommendations, particularly important in Irving’s older housing stock where leaky ducts are common.
- System startup, performance testing, and refrigerant charge verification before the job is considered complete.
- A full homeowner walkthrough covering thermostat operation, filter maintenance, and what to watch for in the first season.
We offer free estimates with no-pressure recommendations, and our proposals are detailed and transparent so you can make a confident decision.
Inside a Typical Service Visit: A Valley Ranch Replacement
Earlier this year, we received a call from Sandra, a homeowner in Valley Ranch — a master-planned community in northwest Irving developed largely in the late 1980s and early 1990s. Her system had been limping along for two summers, and after a repair the previous August, she was hoping to get one more season out of it. By May, it was clear that wasn’t going to happen.
When our technician arrived, he found a 17-year-old unit with a failing compressor and a refrigerant leak that had been repaired once before in the same location — a sign of a chronic stress point rather than an isolated incident. The ductwork, original to the home’s 1989 construction, had several flex duct sections that had partially collapsed in the attic, reducing airflow to the rear bedrooms significantly.
We replaced the system with a properly sized unit, repaired and re-insulated the compromised duct runs, and installed a programmable thermostat matched to Sandra’s schedule. The rear bedrooms, which had been uncomfortable for years, finally cooled evenly. She mentioned that she wished she had replaced the system the summer before — but was glad to head into the hottest months with equipment she could actually rely on.
What Sets Ellis Apart for Irving Homeowners
The DFW market has no shortage of HVAC contractors, but not all of them bring the same depth of experience or commitment to getting the job done right. For Irving homeowners, here is what working with Ellis Air Conditioning and Heating actually means:
- Over 50 years of experience serving the Dallas–Fort Worth area, including Irving and its surrounding communities, gives us a ground-level understanding of the homes and conditions here.
- Our technicians average more than 10 years of tenure with the company, meaning you’re getting experienced professionals — not someone on their first week in the field.
- Ellis is a Carrier Factory Authorized Dealer, which requires us to meet rigorous training and service standards that protect both the quality of the equipment and the integrity of your installation.
- We hold a BBB A+ Rating, NATE certification, and TDLR licensing (Texas License TACLB002064) — credentials that reflect our commitment to professionalism and accountability.
- Our fully stocked service vehicles and large fleet allow us to respond quickly and complete most installations without return trips for parts.
- We provide 24/7 emergency service, honest pricing, and free estimates with no obligation.
When you hire Ellis, you’re working with a company that has earned its reputation over decades — not one that’s still building it.
AC Installation and Replacement in Irving, TX
Ellis Air Conditioning and Heating serves homeowners throughout Irving, TX with AC installation and replacement services backed by more than five decades of experience in the Dallas–Fort Worth area. Whether your current system has finally reached retirement age or an unexpected failure has left you without cooling, our team can respond quickly and get your home back to comfortable.
Irving presents a specific set of challenges for air conditioning equipment. The city’s blend of aging residential neighborhoods west of Loop 12, the denser development in Las Colinas, and the sprawling subdivisions of Valley Ranch and Coppell Road corridors means homes here vary widely in construction era, insulation quality, and duct condition. A system that works well in one home may be completely wrong for a neighbor’s — which is why we size every installation individually and never rely on rule-of-thumb guesswork.
Reach out today for a free in-home estimate. We’ll assess your current equipment, evaluate your ductwork and home envelope, and give you a clear, straightforward recommendation with transparent pricing.